Re: first helical gear

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Jim Pollock on April 22, 2012 at 21:54:32:

In Reply to: Re: first helical gear posted by Jim Pollock on April 21, 2012 at 11:10:01:

I put one of my sample gears in the chuck on my tool and cutter grinder and set one of the teeth on a finger at approximately the pitch diameter of the gear. I then moved the x axis of the grinder 1" and the gear rotated 32 degrees. How do I figure the helix angle from this?

Follow Ups:

Re: first helical gear BillS 09:13:33 04/23/12 (20)
- Re: first helical gear Jim Pollock 17:53:14 04/23/12 (19)
  - Re: first helical gear Jim Pollock 13:24:41 04/24/12 (2)
    - Re: first helical gear Jim Pollock 13:28:27 04/24/12 (1)
      - Re: first helical gear Jim Pollock 13:33:29 04/24/12 (0)
  - Re: first helical gear BillS 10:31:35 04/24/12 (13)
    - Re: first helical gear Josh 13:07:05 04/24/12 (4)
      - Re: first helical gear BillS 13:59:10 04/24/12 (3)
        
        Re: first helical gear josh 15:10:32 04/24/12 (2)
        
        Re: first helical gear BillS 17:23:55 04/24/12 (1)
        
        Re: first helical gear Ron V 16:11:14 04/25/12 (0)
    - Re: first helical gear Jim Pollock 11:45:05 04/24/12 (0)
    - Re: first helical gear Jim Pollock 11:26:51 04/24/12 (6)
      - Re: first helical gear BillS 12:23:20 04/24/12 (5)
        
        Re: first helical gear Jim Pollock 12:26:08 04/24/12 (4)
        
        Re: first helical gear Bill S 14:02:50 04/24/12 (3)
        
        Re: first helical gear Jim Pollock 16:49:29 04/28/12 (2)
        
        Re: first helical gear Rich S 23:45:46 01/15/16 (0)
        
        Re: first helical gear Josh 09:37:51 04/30/12 (0)
  - Re: first helical gear BillS 10:00:04 04/24/12 (0)
  - Re: first helical gear Josh 20:45:41 04/23/12 (0)

Post a Followup