Posted by Tlueken on March 25, 2018 at 16:13:24:
In Reply to: Re: Hobber Work Spindle Runout posted by BillS on March 16, 2018 at 12:30:36:
I have found the tail stock, dead center assembly is way out from center line of the work spindle. .015 vertical up and .02 horizontal towards operator. I am not the original owner of this machine so I am not sure if the tail stack is the original or not. The work arbor was hard chromed and ground for me by a shop I always use. The arbor runs true within .0002 on the bench center.
Post a Followup