Posted by LBMAKEM on March 25, 2013 at 10:06:11:
In Reply to: Chatter marks on gear teeth posted by Tim on March 23, 2013 at 01:07:20:
Hi Tim
Not familiar with the machine but over the years had similar problems.
1) is there any movement in the table back and forth.
2)is the gear bigger than the wormwheel in the table as this will exaggerate any error in 1).
3)The support on the job arbor is it the bearing kind or the 'centre' kind, if the 'centre' kind it might be bottoming in the arbor.