Posted by Dimebag on December 19, 2006 at 09:51:46:
In Reply to: Re: Diameters for an involute spline posted by Ron V on December 18, 2006 at 18:59:30:
I'm not 100% sure what the vernier is, but if I'm right then it can't be used on a hub.
I made 3 pin measurements:
O1,9 : 38,39 mm
O2,1 : 37,77 mm
O2,2 : 37,47 mm
I checked the DIN 5480 standard and found:
O1,9 : 38,32 mm
O2,1 : 37,72 mm
O2,2 : 37,42 mm
This corresponds to 0,03 clearance on tooth's thickness, which is likely to be true.
Dimebag