Re: hobbing a single thread


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by Michael Kelly on October 28, 2000 at 16:32:39:

In Reply to: Re: hobbing a single thread posted by Bill S. on August 16, 2000 at 23:45:01:

The setup did work and we got the part made.
I should have made a larger cutter outside
diameter larger so the part would be able
to be held with a snap center support. We
had to use a support bracket to hold the end
of the shaft which created problems and made it
difficult to hold size. Profitable only as an
educational experience due to the time involved.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]