gear standard

[ Follow Ups ] [ Post Followup ] [ Meshing with Gears Discussion Forum ] [ FAQ ]

Posted by mike on December 02, 2002 at 05:27:02:

hi,
someone can help me?
i'm looking some information about "AMERICAN STANDARD 14 1/2 degree composite system".

is it possible that this standard is the same as ANSI B6.1 and AGMA 201.02???

i need pin diameter and measure over pins for 12/24 spline, 14 1/2 degree, 64 teeth and no offset.
thank you very much

Follow Ups:

Re: gear standard FARZAD 05/21/03 (1)
- gear standard busthaniel 01/25/04 (0)
thread cutting muthu veerappan 12/02/02 (1)
- Re: thread cutting Dennis Kelly 02/05/03 (0)
Re: gear standard DanO 12/02/02 (0)
Re: gear standard michael kelly 12/02/02 (0)

Post a Followup